Carr Lane Roemheld Mfg. Co. Logo
Power Workholding | CNC Vises | Assembly |Die Change | Mold Change | Zero Point Mtg.

Tips for using zero-point clamping systems

By Kip Hanson, Contributing Editor
Article excerpted from April, 2014 issue of Cutting Tool Engineering.


A Carr Lane Roemheld zero-point fixture integrates into a four-sided tooling block.

Similar to the mechanism that grips rotary toolholders on many machining centers, zero-point clamps employ a mounting knob and clamping wedge lock to pull a pallet, fixture or other workholding device—or even the part itself—against the ground face of a zero-point chuck. The retention knob sits inside the chuck bore and offers positional accuracy to within a few tenths of an inch and several tons of clamping force until released through mechanical, hydraulic or pneumatic pressure.

For example, 6"-vise aficionados could permanently mount that all-purpose hunk of iron to a piece of precision-ground tooling plate. Bolt a pair of zero-point knobs to the bottom of the plate, then attach a pair of zero-point chucks to the bed of the machining center. Drop the knobs into the chuck bores, flip the switch and go. That means no more cleaning T-slots or looking for wrenches when switching the vise for a fixture or rotary table. If every machine in the shop is set up like this, changeovers can best be measured in minutes instead of hours.

Read the rest of the article on
Cutting Tool Engineering's web site

More Information on
Carr Lane Roemheld Zero Point Mounting

Innovative Clamping Solutions from Carr Lane Roemheld.
Call 1-800-827-2526 for technical assistance.

Carr Lane Roemheld Mfg. Co.
927 Horan Drive – Fenton, Missouri USA 63026
Phone: (636) 386-8022 – Fax: (636) 386-8034 – Email: info@clrh.com
Copyright © Carr Lane Roemheld Mfg. Co. All rights reserved.
Power Workholding | CNC Vises | Assembly |Die Change | Mold Change | Zero Point Mtg.